Stream Building, Page 4
I began by using a 2.5 inch hole saw bit to cut a hole
for the my 1.5 inch inflow pipe. I then pushed the uniseal into the side
of the barrel, lubed it with some dish washing liquid and pushed the
flex pipe through.
In this pic the unseal for the bottom drain is already in place with the bottom 2 inch pipe sitting flush with the seal.
Next came the 4 inch outflow pipe near the top! Trick: use plenty of slippery liquid soap and bevel the edge with a sander bit on a dremel tool. When pushing the pipe through the Uniseal, use a block of wood to distribute even, strong pressure.
It's tough at first... but just like sitting through an episode of Jerry Springer- YOU CAN DO IT!
All 3 in place.